This is the stock Fiero as the Conversion is about to get under way. The decklid has been removed. Before jacking the car up onto jack stands, remove air cleaner, battery, shift cables from the trans, throttle cable cruse cable and all other items that can be reached from the top. Remove the slave cylinder from the transmission mounting bracket but don't disconnect the hydraulic line, place it off to the side out of the way. It is easier to remove them right now than to wait until the car is up in the air. For a complete list of items to be removed see the Haynes manual.
------------------------------------------------------------------------------------
In addition to all the other items you can remove now. You should also remove the console from the interior and unplug the computer wire harness from the computer. This wire harness will be coming out with the engine, also remove and separate the wire harness plug over on the inside right side wheel well.
------------------------------------------------------------------------------------
Once we have as many things disconnected as we can reach from the top, we can put the car up on jack stands. To get the car at the right height from the floor, you need to have the front tires about 6" off the floor and the distance from the floor to the top of the rear wheel opening is about 45". Secure the car and attach the overhead hoist or the "cherry picker" to the lift plates on the engine.
------------------------------------------------------------------------------------